700R4 to NP241?? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

*72longbed* · 01-26-2005, 10:56 AM

Well I'm not getting much positve feedback on using the NP205 with a stock (unmodified) 700R4 trans., so I've been wondering if it will be a whole lot less trouble to just go with an NP241?? Has anybody done this or have any data on this combo??

From what I read, the NP241 is available in a drivers side and passengers side front output shaft? Is it possible to use a drivers side output in a 71/72 frame??
I can get a really good deal on a Dana 44 with drivers side Diff. housing and was wondering if it could be made to work with a small block chevy motor/ 700R4 trans setup??

Any feedback would be great,
Thanks,
72longbed

01-26-2005, 10:56 AM	#1
72longbed Account Suspended Join Date: Jun 2003 Location: PA Posts: 1,411	700R4 to NP241?? Well I'm not getting much positve feedback on using the NP205 with a stock (unmodified) 700R4 trans., so I've been wondering if it will be a whole lot less trouble to just go with an NP241?? Has anybody done this or have any data on this combo?? From what I read, the NP241 is available in a drivers side and passengers side front output shaft? Is it possible to use a drivers side output in a 71/72 frame?? I can get a really good deal on a Dana 44 with drivers side Diff. housing and was wondering if it could be made to work with a small block chevy motor/ 700R4 trans setup?? Any feedback would be great, Thanks, 72longbed



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.