|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-29-2005, 06:57 PM
|
#1 |
|
Senior Member
Join Date: Sep 2004
Location: Wakaw, Sask, Canada
Posts: 3,180
|
Plastic vent flaw normal?
I just bought a set of reproduction black plastic defrost/heater vents, and was wondering if there should be a noticeable round ridge on the top of one. It is obviously a casting flaw, and only one side has it..the other is smooth like factory. I was just interested to know if this is normal for these parts or should I try to exchange the one vent? Thanks.
__________________
"You can take the man out of PA, but you can't take PA out of the man" |
|
|
| Bookmarks |
|
|
Threaded Mode