rear brace fabrication after tank install - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Joe67 · 02-08-2005, 04:30 PM

I took these pics during the installation of my rear fuel cell this past weekend.
I'll remove it once It is properly located to clean up the frame appearance

I removed the rear brace support to clear the tank. I am considering the fabrication of another brace to go between the frame rails or can I just run without anything there?

I plan to run a rear roll pan so I am not concerned about the rear bumper brackets. Is there anything else I should be concerned about back there?

Thanks!
Joe

02-08-2005, 04:30 PM	#1
Joe67 67 is sold Join Date: Apr 2001 Location: Troy, Michigan Posts: 6,738	rear brace fabrication after tank install I took these pics during the installation of my rear fuel cell this past weekend. I'll remove it once It is properly located to clean up the frame appearance I removed the rear brace support to clear the tank. I am considering the fabrication of another brace to go between the frame rails or can I just run without anything there? I plan to run a rear roll pan so I am not concerned about the rear bumper brackets. Is there anything else I should be concerned about back there? Thanks! Joe __________________ Joe - Formerly 67c10step ------------------------------- 1967 Chevy Stepside - ECE 4/6, fuelcell, 5lug - SOLD gr8lakes - My ebay auctions Click here to order forum apparel :: Click here to become a subscribing member



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.