T400 with NP205 questions?

[cheyenne10]

Who can verify the lengths of a few setups for me. I would like distance from front of bell housing to center of yoke on rear output shaft of transfercase on a T400 and NP205 setup? Is there a difference in length depending on which model adapter is used? (there is the newer round adapter and figure 8 older version).

Also need the same on

a T350 and NP205 setup (version I will switch away from)?

and 700R4 with T350 adapter and NP205 transfercase?

I hope to pick one and keep the stock mounting location on transfercase cross member which allows me to keep my drivelines too and this will hopefully move motor new BB 2-2.5" forward in engine compartment.

I want to lay it all out before I buy a used setup to rebuild or order a Bowtie Overdrive 700R4 and find out lots of stuff moves or doesn't fit perfect.

thanks for advise and help.