Disc brake pedal assembly questions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Bowtiefreak · 02-27-2005, 04:57 PM

I got a couple questions:

Is there any difference in the pedal assembly on a manual pedal assembly in comparison to a truck that was already equipped with power brakes.

Do I need a different rod that goes into the brake booster. The one that is connected to the brake pedal??

Also, I got my assembly apart right now to clean a re-assemble and I pressed out the shaft that holds the actual pedal into the stamped housing. While getting this out I noticed that there are some sort of plastic bushings in there on each end. Are these available anywhere to replace? And what kinda of grease was used in there?

Help if you can,

Thanks alot everyone.

02-27-2005, 04:57 PM	#1
Bowtiefreak Registered User Join Date: Jul 2003 Location: LeRoy, Mich. Posts: 854	Disc brake pedal assembly questions I got a couple questions: Is there any difference in the pedal assembly on a manual pedal assembly in comparison to a truck that was already equipped with power brakes. Do I need a different rod that goes into the brake booster. The one that is connected to the brake pedal?? Also, I got my assembly apart right now to clean a re-assemble and I pressed out the shaft that holds the actual pedal into the stamped housing. While getting this out I noticed that there are some sort of plastic bushings in there on each end. Are these available anywhere to replace? And what kinda of grease was used in there? Help if you can, Thanks alot everyone. __________________ 1968 Chevy C10 Short Fleetside/Wood floor ECE 4-6 Drop / 406 Small Block 1971 Chevelle 427 Big Block



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.