Rocker Panel replacement..... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

ChadMorris · 02-28-2005, 08:45 AM

I have been looking around at replacement rockers, and want to know just what is getting replaced........I have seen 2 different types.....is there an inside and outside rocker? Or was I looking at the wrong thing....What I saw only cost about $40, and had the metal strip that the Door seal mates with and runs up about 4 or 5 inches up the door pillers.....

Here is a pic of the Pas side that I want to replace......

Also pics of my truck that I am working on.... Passed down from my Grandfather

Getting my Hurst floor shifter in today, also have my Clifford intake, and Holley 390 ready to install in the next week or so......

Any suggestions welcome...............

02-28-2005, 08:45 AM	#1
ChadMorris Newbie truck Rebuilder! Join Date: Dec 2004 Location: Huntsville, Al Posts: 160	Rocker Panel replacement..... I have been looking around at replacement rockers, and want to know just what is getting replaced........I have seen 2 different types.....is there an inside and outside rocker? Or was I looking at the wrong thing....What I saw only cost about $40, and had the metal strip that the Door seal mates with and runs up about 4 or 5 inches up the door pillers..... Here is a pic of the Pas side that I want to replace...... Also pics of my truck that I am working on.... Passed down from my Grandfather Getting my Hurst floor shifter in today, also have my Clifford intake, and Holley 390 ready to install in the next week or so...... Any suggestions welcome............... __________________ "Old Blue" 1964 GMC Fleetside in pieces 350 TPI with 700R4 tranny now installed( well kinda propped in place until the tranny crossmember is bolted in !!!!! 1995 Toyota 4runner , 197,000 miles and going... 2007 Honda Odyssey Van (Wifes car)



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.