Question for others with 1 piece driveshaft in lwb - The 1947 - Present Chevrolet & GMC Truck Message Board Network

toddtheodd · 03-02-2005, 04:06 PM

I have recently upgraded my lwb to a one piece driveshaft. They removed the bracket that was holding the carrier bearing and ran the driveshaft through the original hole in the crossmember.
My question is this.
If I lift my truck up by the frame, like when I get my tires changed, will the driveshaft hit the bottom of the crossmember's hole?
And if I load my truck down with.... stuff.... will it then rub on the top of the hole?
Just something I didn't even think about until after it was done and I was looking at it.

Todd

03-02-2005, 04:06 PM	#1
toddtheodd The oddest Todd around Join Date: May 2004 Location: Miami, Florida Posts: 1,418	Question for others with 1 piece driveshaft in lwb I have recently upgraded my lwb to a one piece driveshaft. They removed the bracket that was holding the carrier bearing and ran the driveshaft through the original hole in the crossmember. My question is this. If I lift my truck up by the frame, like when I get my tires changed, will the driveshaft hit the bottom of the crossmember's hole? And if I load my truck down with.... stuff.... will it then rub on the top of the hole? Just something I didn't even think about until after it was done and I was looking at it. Todd __________________ "The greatest pleasure is to vanquish your enemies and chase them before you, to rob them of their wealth and see those dear to them bathed in tears, to ride their horses and clasp to your bosom their wives and daughters." Ghengis Khan IIOY???



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.