03-05-2005, 10:32 PM | #1 |
Senior Member
Join Date: May 2004
Location: Queen Creek, AZ
Posts: 1,005
|
rearend
I have a 12-bolt 1/2ton rear from a late 70s Chevy that I am going to set in place of my Eaton rear. Do I need to make any mods to the driveshaft to match up to the pinion on the new rear?? The driveshaft is coming from a T400 tranny w/slip yoke. I know I have to get a crossover u-joint. Does anybody know the part#?? Also, what about the brake line?? I plan on dropping the Burb about 6", so I was going to get the Super Track Bar from ECE, so I wouldn't have to get it later and it bolts to the passenger side shock mount I believe.
|
Bookmarks |
|
|