building a 70 chev stepside... customed

[daesch]

Anybody know if i am going to have to change my perches or shock mounts?
I have 82 or so 3/4 ton axels.. dana 44 and 14 bolt semi float axels that I am going to stuff underneath my 70 chevy sb stepside...

when I am finished it will be..

350 crate motor ( newer single rear main seal, valve covers bolt thru center)
I think i need motor mount conversion here??!?
Also not sure about transmition.. i have a sm456 with np205 but am not sure if this newer motor has a spot for putting clutch linkage?

its is going to get 6 inch of lift by bds.
35 inch tyres

pontiac gto seats..

I need headers that wont interfere with clutch linkage... anybody have any good suggestions?

just got the frame back from sand blaster.. good shape..

I have most the parts i need, except a whole lot of minor parts (about 1000 $ worth of odds and ends)

and at least a year of hard work.. ( the shame is it will never go off road.. thats what the 86 chevy and grizzly is 4)

project big toy has begun....
any advice anybody can give would be much appreciated!