pan hard bar question about lowering truck - The 1947 - Present Chevrolet & GMC Truck Message Board Network

modifiedGMC · 05-29-2005, 11:41 AM

Does the panhard bar have to be made adjustable when you drop the rear? I was using a cable hoist ran under the rear end and connected to the frame above it to pull the truck down to get an idea of the drop I want. It would only go about 2" and stopped but the snubbers were NOT bottomed out, so I figured the panhard bar was stopping it. any ideas?
Could the rear coils be cut and then bend the end back into the curl for mounting?

05-29-2005, 11:41 AM	#1
modifiedGMC Registered User Join Date: Oct 2004 Location: Walker Co. Alabama Posts: 474	pan hard bar question about lowering truck Does the panhard bar have to be made adjustable when you drop the rear? I was using a cable hoist ran under the rear end and connected to the frame above it to pull the truck down to get an idea of the drop I want. It would only go about 2" and stopped but the snubbers were NOT bottomed out, so I figured the panhard bar was stopping it. any ideas? Could the rear coils be cut and then bend the end back into the curl for mounting? __________________ If it don't fit, force it,...If it still don't fit , modify it 'till it does fit !!!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.