Header Flange Stiffeners - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Russell · 05-31-2005, 01:07 AM

Who was it that was making the header flange stiffeners on the forum? They were three peice units that were about an inch thick, They went around head side of the flange, and forced the flanges to seal tightly rather than leak like headers always do. I'm sick and tired of leaking ticky exhaust, so I wanna buy a set of these things to make things work a bit better!

Also, do you guys have any tricks for making the head to header seal better? I straightened the flanges out the best I could using a straight edge. Would using double gaskets work?

05-31-2005, 01:07 AM	#1
Russell Professional Grade Join Date: May 2003 Location: Fort McMurray, Alberta Posts: 7,915	Header Flange Stiffeners Who was it that was making the header flange stiffeners on the forum? They were three peice units that were about an inch thick, They went around head side of the flange, and forced the flanges to seal tightly rather than leak like headers always do. I'm sick and tired of leaking ticky exhaust, so I wanna buy a set of these things to make things work a bit better! Also, do you guys have any tricks for making the head to header seal better? I straightened the flanges out the best I could using a straight edge. Would using double gaskets work? __________________ 1995 Chevrolet 2 Door Tahoe (6.6L LBZ Duramax / ZF6 / NP241 with 1 ton solid axle swap) Last edited by Russell; 05-31-2005 at 01:09 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.