Terrible news when I pulled valve cover - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Yukon Jack** · 06-13-2005, 09:00 PM

I put in the tool that thread into the spark plug hole and uses compressed air to hold the valves closed when pulling the valve springs. When I attached the air line there was still some air that was passing in the cylinder with about 100 psi from the compressor. Should there be no air passing or is a little okay when I pull the springs?

Definitely is holding some air as when you pull the air hose off there is a good bit of air pressure built up.

06-13-2005, 09:00 PM	#33
Yukon Jack Post Whore Join Date: Feb 2000 Location: Rose Hill, KS, USA Posts: 12,684	I put in the tool that thread into the spark plug hole and uses compressed air to hold the valves closed when pulling the valve springs. When I attached the air line there was still some air that was passing in the cylinder with about 100 psi from the compressor. Should there be no air passing or is a little okay when I pull the springs? Definitely is holding some air as when you pull the air hose off there is a good bit of air pressure built up. __________________ 1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.