Flipping upper A-arms?

[FirstGen]

Originally Posted by fastbagged68

Flipping ball joints wont change the lenght of the control arm. If you want more camber take out your shims if you haven't yet.

No shims left to take out. Actually it should push or pull the ball joint a small amount in one direction or the other at that same ride height. Think about it, well it might be different for you but with my tubular uppers there is a 1/4" thick plate the ball joint mount to... if you were to say put the ball joint on the bottom of that 1/4" you effectively move the ball joint because with a lowered truck the angle of the control arm is not perpendicular with the crossmember anymore. I'm not talking about a huge difference but I just need another degree or two...