Big Block 4WD - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jec · 08-05-2005, 12:59 PM

Has anyone done this?

My truck was converted many years ago and I have owned for 7 years. The engine is the original 402 and a manual SM465/NP205 combo was installed. The front crossmember and 2WD suspension was completely removed. A 4WD crossmember and frame mounts were installed, probably from a small block 4WD truck.

After dismantling the truck (see previous posts for pics) for restoration, I have noticed both left and right exhaust manifolds have been rubbing on frame. This driver's side is also cracked and may have been caused by the contact.

After a little research, I believe the motor mounts are wrong for this application. The engine needs to sit about a 1/2" higher.

Does anyone know the type of mounts that I could use for this?

08-05-2005, 12:59 PM	#1
jec Registered User Join Date: May 2000 Location: Middletown, Ohio Posts: 131	Big Block 4WD Has anyone done this? My truck was converted many years ago and I have owned for 7 years. The engine is the original 402 and a manual SM465/NP205 combo was installed. The front crossmember and 2WD suspension was completely removed. A 4WD crossmember and frame mounts were installed, probably from a small block 4WD truck. After dismantling the truck (see previous posts for pics) for restoration, I have noticed both left and right exhaust manifolds have been rubbing on frame. This driver's side is also cracked and may have been caused by the contact. After a little research, I believe the motor mounts are wrong for this application. The engine needs to sit about a 1/2" higher. Does anyone know the type of mounts that I could use for this?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.