FINALLY...but have a question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Crush · 08-25-2005, 10:19 AM

Well as of 10:30 last night the "project" has it's SSBC Force 10 front calipers in place. It's been an uphill battle but they are finally on and clearing the wheels.

Here's the question...In order to get them to clear the wheels I had to run a 5/16" spacer....this gives me about 1/4" of clearance between the caliper and the wheel...is that gonna be enough? I was told by SSBC that "As long as they clear when everything is torqued down, it doesn't matter if it's 1/16ths of an inch." I'm just concerned with flexing or something. Am I just being concerned for no reason?

08-25-2005, 10:19 AM	#1
Crush Active Member Join Date: Nov 2003 Location: Jacksonville, FL Posts: 307	FINALLY...but have a question Well as of 10:30 last night the "project" has it's SSBC Force 10 front calipers in place. It's been an uphill battle but they are finally on and clearing the wheels. Here's the question...In order to get them to clear the wheels I had to run a 5/16" spacer....this gives me about 1/4" of clearance between the caliper and the wheel...is that gonna be enough? I was told by SSBC that "As long as they clear when everything is torqued down, it doesn't matter if it's 1/16ths of an inch." I'm just concerned with flexing or something. Am I just being concerned for no reason? __________________ D.M.C -FF-



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.