2" drop spindle question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

red86chevy · 08-26-2005, 10:15 PM

If i install 2" drop spindles on my '86 will I have any trouble with pieces not fitting properly or will it be just like bolting a stock one back up? I.E....will any parts have to be cut on or grinded on?

About how long will changing both spindles take? (what ever it is I can add on about 2 extra hours)

And also in Sumitt it has a set for heave duty rotors(1.25") and a set for 1" rotors. What part of the rotor do I need to measure to find out which ones I have.

They also have a little astric (*) beside the part number which says additional parts may be required. What parts might they be refering too?
Sorry for all the questions. I'm 19 and still learning.
Thanks,
Jeremy

08-26-2005, 10:15 PM	#1
red86chevy Registered User Join Date: Jun 2005 Location: sc Posts: 77	2" drop spindle question If i install 2" drop spindles on my '86 will I have any trouble with pieces not fitting properly or will it be just like bolting a stock one back up? I.E....will any parts have to be cut on or grinded on? About how long will changing both spindles take? (what ever it is I can add on about 2 extra hours) And also in Sumitt it has a set for heave duty rotors(1.25") and a set for 1" rotors. What part of the rotor do I need to measure to find out which ones I have. They also have a little astric () beside the part number which says additional parts may be required. What parts might they be refering too? Sorry for all the questions. I'm 19 and still learning. Thanks, Jeremy __________________ 86 c-10 383 w/ sportsman II heads comp 286h cam Edlbrock RPM Performer intake Holley 750 th350 w/2400 stall 3.73 gears with powertrax No-Slip posi unit. Just broken in good. Will get a 1/4 time this week. Last edited by red86chevy; 08-26-2005 at 10:22 PM.*



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.