Can I use a sandblaster? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

RICHARD MORGAN · 10-10-2005, 08:51 AM

I have a few rust spots i'd like to clean up and I heard a sand blaster was the way to go. Do you think my compressor is big enough to run a small sandblaster?

http://www.northerntool.com/webapp/w...07226&R=207226

Ingersoll-Rand
Motor: 2 HP/ 5 Peak HP - single phase motor
Volts: 110 Volts
PSI: 5.7 CFM @ 90 PSI; 4.9 CFM @ 135 PSI
Max PSI: 135 PSI
Tank Size: 24 gallon vertical
Pump: Two stage splash lubricated belt driven pump
Air Outlet: 1/4in. NPT
100% continuous duty
Drain System: Manual Drain
Start Up Kit: 15920083, sold separately
Dimensions: 23in.L x 25in.W x 51in.H
U.S.A.
Model SS3R2-GM

10-10-2005, 08:51 AM	#1
RICHARD MORGAN Registered User Join Date: Jan 2004 Location: HERNDON VA Posts: 216	Can I use a sandblaster? I have a few rust spots i'd like to clean up and I heard a sand blaster was the way to go. Do you think my compressor is big enough to run a small sandblaster? http://www.northerntool.com/webapp/w...07226&R=207226 Ingersoll-Rand Motor: 2 HP/ 5 Peak HP - single phase motor Volts: 110 Volts PSI: 5.7 CFM @ 90 PSI; 4.9 CFM @ 135 PSI Max PSI: 135 PSI Tank Size: 24 gallon vertical Pump: Two stage splash lubricated belt driven pump Air Outlet: 1/4in. NPT 100% continuous duty Drain System: Manual Drain Start Up Kit: 15920083, sold separately Dimensions: 23in.L x 25in.W x 51in.H U.S.A. Model SS3R2-GM



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.