![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Oct 2005
Location: redlands, ca
Posts: 112
|
suspension/exhaust/etc recommendations
I have a 70 c-10, 292, 4sp w/ granny. I have been working on it for about a month now, and am ready to really dig into to it.
Last weekend I was able to pickup a rebuilt 292 for $700. It looks good - here are a couple of pictures. ![]() ![]() ![]() I bought an offy and a 390cfm holley for it. I am ready to pull out the old engine and put in the new one. I need to make some decisions about what to buy next. Over the next couple of weeks, I can spend about $800, then more around Nov 1st. (1)cam should be done now since I have the engine out,right? (2) should i get new valve springs if i step up the cam - how much would they cost? (3)what kind of gains could I expect from changing the cam, changing out the springs, bigger carb, and dual exhaust? What are your thoughts regarding suspension? I would like a 2/4 drop, so that the truck is level and relatively low. I assume that most of the kits they sell are for V8s. (4)Any idea how much higher the front end will be with the 292? also, should I just go with the bare minimum right now, so that I can some of the other stuff. eventually I would like to add: Front and rear coils, front and rear sway bars, adjustable trac bar and front and rear shocks (6)Should I just go with shocks and coils to start off, then add the other stuff later? (7)Can you recommend any other online stores that I should check out for suspension? I broke off one of the bolts when removing the pipe, but I could probably figure something out to get me by for a while, if I should go with the suspension stuff first. Here is the exhaust stuff I am looking at: stovebolt headers clifford headers clifford x pipe (8)Which setup would you recommend, - just stovebolt, clifford headers & x pipe, clifford x and stovebolt, etc or a different brand/setup all together? When I started pulling things apart this weekend, I noticed that I am missing a few fasteners - ie the tranny and motor only had 4 bolts holding them together. (9)How does this look as a solution? http://www.stoveboltengineco.com/aca...?productid=143 (10) list of importance/buying order for the above items? |
![]() |
![]() |
Bookmarks |
|
|