Laying out the 72 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Bagd72Chevy · 11-09-2005, 01:44 PM

Hey guys,

My truck is already bagged on 20's (27" tall tires) with air rides control arms and two inch dropped spindles. It lays the crossmember but I think I want to go to the frame.

My Questions are about the front.

I think I'm going to crossmember drop it 1.25 inches to keep stock steering, then Z it 2 inches or so to get that last bit. Will this get the frame down??
Also will I run into problems with the tubular upper control arms and the steering shaft??

Thanks guys,
Ryan

11-09-2005, 01:44 PM	#1
Bagd72Chevy C10 Collector Join Date: Oct 2003 Location: Baton Rouge, LA Posts: 417	Laying out the 72 Hey guys, My truck is already bagged on 20's (27" tall tires) with air rides control arms and two inch dropped spindles. It lays the crossmember but I think I want to go to the frame. My Questions are about the front. I think I'm going to crossmember drop it 1.25 inches to keep stock steering, then Z it 2 inches or so to get that last bit. Will this get the frame down?? Also will I run into problems with the tubular upper control arms and the steering shaft?? Thanks guys, Ryan



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.