Question about Flexplate on SBC 400 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

svgould · 11-12-2005, 08:17 PM

Hi,

Can the flexplate on a SBC 400 be installed backwards?? If so, how do you tell which side faces the engine and which side faces the tranny? I tried to start my new motor today, but the starter teeth don't retract enough to clear the ring gear on the flexplate.....it is barely hitting, just rubbing. I tried two different starters and both do the same thing. Just wondering if my flexplate is on backwards if this is possible??? Any help would be appreciated.
Thanks in advance,

11-12-2005, 08:17 PM	#1
svgould Active Member Join Date: Jul 2003 Location: Boise Idaho Posts: 296	Question about Flexplate on SBC 400 Hi, Can the flexplate on a SBC 400 be installed backwards?? If so, how do you tell which side faces the engine and which side faces the tranny? I tried to start my new motor today, but the starter teeth don't retract enough to clear the ring gear on the flexplate.....it is barely hitting, just rubbing. I tried two different starters and both do the same thing. Just wondering if my flexplate is on backwards if this is possible??? Any help would be appreciated. Thanks in advance, __________________ 1971 SWB SOLD LT1 motor / 4l60E transmission ECE front dropped spindles with stock height springs 4" rear springs Coys Wheels 18 x 8 all the way around Hydratech hydroboost brake system



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.