|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-27-2005, 12:21 AM
|
#1 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,068
|
Welder & Plasma Cutter for the Garage
Christmas is getting close & I'm going to try & get a welder and/or a plasma cutter for frame mods (c-sections, crossmember notches, & 'Z's).
I'm looking @ Millers stuff & like the Millermatic 210 & the Spectrum 375 'Cutmate'. The 210 is Single phase 230v & can mig up to 3/8" single pass & the '375-Cutmate' is single phase 240v & can cut up to 3/8" thick or do 1/2" shear. Sound like overkill for the home builder/fabricator? Any recommendations from those that are already set-up?
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
| Bookmarks |
|
|
Threaded Mode