Patch panel replacement order???

[muddpile]

My parts will be here in a week or so, so I am getting ready to start cutting and welding. I will be doing both sides of the truck with the following pieces:
-Front Floor pans
-Outer and Inner rockers
-Cab corners
-Rear floor pan patch panels (where the rocker meets the seat area)
-All four cab supports
I was just wondering where to start with this, like, what order do I cut and replace etc. The cab corners and rockers are theoretically gone already, replaced with expanding foam and tin foil. The rust only goes 6" or so into the floor from either side, so I may just have to use 1/2 the front floorpan patches. Anyone have any advice or pics? Thanks!