PWR steering conversion question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

skillet · 12-09-2005, 12:04 PM

My '69 350 has manual steering and I am thinking about converting to pwr. steering. It has a short water pump and the lower pulley is currently a single groove. My question is, don't I need a 2 groove lower pulley for the conversion? In a pwr. steering article I read about this conversion they used a "big block" pulley for the lower pulley. Is this the way to go? I saw an Ebay auction for a kit, but I noticed they only have the single groove pulley that bolts onto the pwr steering pump. Thanks very much for any info.

12-09-2005, 12:04 PM	#1
skillet Registered User Join Date: Sep 2000 Location: denton, tx, usa Posts: 176	PWR steering conversion question My '69 350 has manual steering and I am thinking about converting to pwr. steering. It has a short water pump and the lower pulley is currently a single groove. My question is, don't I need a 2 groove lower pulley for the conversion? In a pwr. steering article I read about this conversion they used a "big block" pulley for the lower pulley. Is this the way to go? I saw an Ebay auction for a kit, but I noticed they only have the single groove pulley that bolts onto the pwr steering pump. Thanks very much for any info. __________________ 69 SB GMC LWB Fleetside 350, 09 Pontiac Vibe 2.4 liter



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.