Front Shaft - The 1947 - Present Chevrolet & GMC Truck Message Board Network

wedgemon · 01-12-2006, 12:09 PM

My slip joint front shaft is shot. Driveline shop says its the wrong length. I measured it at 26-27 inches from center of front uni bearing to back of flange. Which looks appropriate installed - about 1/2 to 3/4 inch of showing slip wear. That seems right. I'm trying to replace it, they want too much for their rebuilt one and wont repair mine - after saying they would for $50.

Would any of you know what the correct length for this should be?

This is on my stock 1980 K10 long bed, 350 engine SM465/NP205 Trans & Case.

Any help would be appreciated. It's gonna snow again soon.

Thanks! - Dave

01-12-2006, 12:09 PM	#1
wedgemon Registered User Join Date: Jul 2004 Location: Spanish Springs, NV Posts: 1,171	Front Shaft My slip joint front shaft is shot. Driveline shop says its the wrong length. I measured it at 26-27 inches from center of front uni bearing to back of flange. Which looks appropriate installed - about 1/2 to 3/4 inch of showing slip wear. That seems right. I'm trying to replace it, they want too much for their rebuilt one and wont repair mine - after saying they would for $50. Would any of you know what the correct length for this should be? This is on my stock 1980 K10 long bed, 350 engine SM465/NP205 Trans & Case. Any help would be appreciated. It's gonna snow again soon. Thanks! - Dave __________________ 2003 Silverado K1500 Z71 - Arrival Blue 1973 K5 Cheyenne Blazer 350/TH350/NP203 Kids Trucks:92 K1500 Blazer 5.7/700R4 4" lift. RETIRED: 1980 Scottsdale 4x4 Founding Member: "TILT WHEEL BELLY." Club



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.