alignment troubles - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Johns70 · 04-23-2002, 10:55 PM

went to have my truck aligned after a complete rebuild, upper and lower control arm shaft kits and ball joints,new drop spindels.but they said they could not get it to what they thought was specs,{their book only went back to 83} not enough bolt for shims to get proper caster and camber on the right side.does anybody have the factory specs for this and toe? if this is true then the right side must have been hit in an accident and tweaked somthing because there is plenty of room left for more shims on the left side,and this would piss me off because i just had the rattleing rebuilt motor out and i could have put another crossmember in at that time.

------------------
project 70 chev swb rebuilt 396bb{402}rebuilt th-400 3.73 limited slip 4/5 drop

04-23-2002, 10:55 PM	#1
Johns70 Registered User Join Date: Dec 2001 Location: Spring Creek, nevada. U.S.A. Posts: 456	alignment troubles went to have my truck aligned after a complete rebuild, upper and lower control arm shaft kits and ball joints,new drop spindels.but they said they could not get it to what they thought was specs,{their book only went back to 83} not enough bolt for shims to get proper caster and camber on the right side.does anybody have the factory specs for this and toe? if this is true then the right side must have been hit in an accident and tweaked somthing because there is plenty of room left for more shims on the left side,and this would piss me off because i just had the rattleing rebuilt motor out and i could have put another crossmember in at that time. ------------------ project 70 chev swb rebuilt 396bb{402}rebuilt th-400 3.73 limited slip 4/5 drop __________________ 69 chevy short wide box project 70 GMC jimmy project



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.