Clutch linkage question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jmanz69 · 04-24-2002, 08:45 PM

I have a complete clutch linkage from a doner, but when I put the bell crank in place it seems way too close to the frame. I'm supposed to have a braket on the frame that the other ball attatches to right? The engine side has a bracket that bolts to my 327 with no problem, is there something I am doing wrong. Guy I got it from said it was out of a V8 truck. He was going to auto and I was going to 4-spd. Seemed like a good thing to get at the time. Any idea if I can buy a frame bracket anywhere? Also, any one have a diagram of how it all goes together? I had a Chiltons manual around, but it is missing now.

04-24-2002, 08:45 PM	#1
jmanz69 Careful, they attack... Join Date: Aug 2001 Location: Waterford, MI, USA Posts: 1,107	Clutch linkage question I have a complete clutch linkage from a doner, but when I put the bell crank in place it seems way too close to the frame. I'm supposed to have a braket on the frame that the other ball attatches to right? The engine side has a bracket that bolts to my 327 with no problem, is there something I am doing wrong. Guy I got it from said it was out of a V8 truck. He was going to auto and I was going to 4-spd. Seemed like a good thing to get at the time. Any idea if I can buy a frame bracket anywhere? Also, any one have a diagram of how it all goes together? I had a Chiltons manual around, but it is missing now.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.