Couple more questions, baggin a 79.
Ok, so as most of you know, I started with a full frame off build. Painted frame in POR-15. Chopped my crossmember up front 1.5" got my top bag plates bolted on. getting ready to run some lines for the front before I bolt the bag up. Just wondering where everyone ran their lines to keep them out the way of everything? I was thinking of drilling a hole in the side of where the spring would sit in the crossmember. then routing my hose to that little crossmember all the way in the front and mounting my valves on there. pretty much right below the radiatior.
Second part is the back.... I got my KP 6 link kit all loosely bolted up since I dont have my rearend in yet. Made my own set of 10" notches for the rear, (boy are they gonna be a pain to weld with how the frame changes dimensions) And now I cant decide how Im gonna plumb out the rear. I want to run a nitrogen cylinder in the bed, maybe a 8 or 12 gallon tank under the bed and ill have a engine driven comp for normal everyday use. I also plan on putting in a fuel cell under the bed. But I cant decide how I can fit all this under there LOL. Just lookin for some ideas on what you guys did to make your install as clean as possible.
|