crankshaft endfloat - .001"-.006" ya right!! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Greubin · 03-25-2006, 07:11 PM

I pulled the th350 out of my truck to install the 700r4 today. While i was checking things out on the flexplate area, i checked the crank end float which I found to be about 1/16", forget about a few thou's of an inch

...I'm totally bummed. The engine runs strong - so now what do I do - I hate to pull the eng. at this point, I'm not ready for that. **** it, I'm installing the tranny throwing caution to the wind, may the engine gods have mercy!!

I'm pulling the damn thing - better to do it right than be sorry in the long run.

03-25-2006, 07:11 PM	#1
Greubin Registered User Join Date: Dec 2005 Location: SJC Posts: 158	crankshaft endfloat - .001"-.006" ya right!! I pulled the th350 out of my truck to install the 700r4 today. While i was checking things out on the flexplate area, i checked the crank end float which I found to be about 1/16", forget about a few thou's of an inch ...I'm totally bummed. The engine runs strong - so now what do I do - I hate to pull the eng. at this point, I'm not ready for that. **** it, I'm installing the tranny throwing caution to the wind, may the engine gods have mercy!! I'm pulling the damn thing - better to do it right than be sorry in the long run. __________________ ___________ Greubin '71 C20 custom - GM Crate 350CI/290HP, BTO 700R4 level II, Qjet, and HEI Last edited by Greubin; 03-26-2006 at 02:16 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.