|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-01-2002, 11:08 AM
|
#1 |
|
Registered User
Join Date: Feb 2002
Location: Vacaville, CA
Posts: 2,746
|
Question About Taking Apart a Bed
I am going to put a metal floor in my truck to replace the wood one, and I bought a old bed that I am taking apart. The one part I can't figure out is how to get the 4 "screws" out that hold the upper front corners of the bed together. They are stuck too tight to remove with a screwdriver, but I don't want to drill them out because they go thorough the nut that is welded to the front panel (which I also need to use) any ideas?
__________________
70 C/10 Light Red 350/TH350, HEI, Duals w/40 series Flows, 91 seat, LED taillights 99 Pontiac S/C GTP, SLP Ram Air hood, GMPP Konis & springs 95 Neon ACR, MP PCM, AFX UDP, 3.0 CAI |
|
|
| Bookmarks |
|
|
Threaded Mode