|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-05-2006, 02:04 PM
|
#1 |
|
Registered User
Join Date: Nov 2001
Location: Springfield, MO
Posts: 2,929
|
upper A-arm adjustment
Hey all, this may get long but hopefully not too confusing. I recently replaced all the suspension parts on the front end of my truck and went to 2 ½ inch drop spindles and stock height springs. My question is on the upper A-arm connection. The rod that goes from front to rear that the studs on the frame go through seems like I remember can move by screwing it front to rear. How are these set correctly? I remember putting them together and bolting everything up. The truck has been aligned but I am not happy with it. I am going back in to use some of the new values I found on this site recommending more positive caster.
Before I go back in I want to know if these are to be adjusted in some manor? I hope you understand my questions… Thanks in advance Dave
__________________
Dave 1968 Custom Chevy with turbo charged 5.3 gen III 4l80e swap 1967-71 GMC 3/4 ton long step 4x4 (not sure what year exactly?) "A good friend will bail you out of jail...but a true friend will be sitting next to you saying "that was frekin awesome". "If it doesn't fit force it...If it breaks then it needed to be replaced anyway!" Last edited by Custom 68; 04-05-2006 at 03:12 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode