Dust shield and how to install....

[tripleblack]

i bought a disk brake setup from McGaugys and i do not know how to install the dust shield. Well, it never came with any bolts but they clearly mount onto the spindle in 3 places. Where would i get the bolts? a hardware store? and how far can the bolt head come out before it rubs against the rotor. Another thing, on the spindle the first thing i install is the shield, then that little round metAl piece with the rubber inside, or vice versa? The bleeder valve on the caliper should be facing up right? And the last thing is the last big screw that goes on the spindle, does that need to be torqued down and if so how much? of course i will install the cotter pins after its all done. I know that is a lot to ask but i appreciate the help and still would be stuck a long ways back if it were not for this board. thanks.