The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-03-2006, 02:53 PM   #1
Tom Vogel
2WD Jimmy
 
Tom Vogel's Avatar
 
Join Date: Mar 2005
Location: Davis County, Utah
Posts: 2,565
Clutch linkage questions

The attachment is a picture of part of my clutch linkage. This is the peice that bolts to the engine block that supports the Z-bar on the engine side. It is an NOS item that I purchased years ago. You can see the felt seal below the ball joint... my question is this, is there supposed to be some kind of an O-ring on that ball joint where that groove is machined around the circumference?
Also, anyone got a picture of the rod going into the cltch fork? Im using a GM heavy duty clutch fork but there is no hole in the end, just a dimple?
Thanks in advance... Tom
Attached Images
 
Tom Vogel is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:52 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com