Anyone have a 90-95 Chevy truck with a 5.7?

[Russell]

Hey guys!

Does anyone here have a 90-95 Chevy truck with a 350 in it? I'm needing a few serpentine bracket pics. I had some 4.3 brackets on my truck, but didn't feel my pass side bracket was solid enough to hold up. However, I've been looking at ebay etc, and I think the 90-95 brackets may be exactly what I am needing.

However, before I go buy anything, I'd love to see a few pictures of them bolted up to an engine as there are a few things I need to know.

First is how high the belt sits when everything is installed. My TPI throttle body sits about 5 inchs above the intake to block making line, and the belt, nor anything else can sit higher than that.

Second is how the pass side bracket bolts up. In the pictures I've seen online, the bracket bolts into two or three holes up tops in the head, then the two bolt holes down by the bottom of the block. If thats the case, that'd be absolutely perfect as I have the top two holes, and the bottom hole, but not the third one up top.

Third is how the tensioner is run. I need to know if I am going to have tensioner to air intake / throttle body clearance issues. From the center of the throttle body, I can't have the tensioner sit closer than 4.5 inches from the center of the water pump shaft.

Thanks guys!