|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-09-2006, 12:51 PM
|
#1 |
|
Registered User
Join Date: Jan 2005
Location: Colorado Springs
Posts: 693
|
Interior restoration questions
I started taking apart my 70 K5 took the top off and the home maid rear side panels getting it ready to start sanding and getting ready to paint. I am changing the body color from burgundy to a metallic bronze so I will be totally stripping the inside interior out to paint match.
My questions are does anyone make replacement seat cover kits for Blazers? I have looked at my LMC and Manes Truck Parts catalog and have only found replacement seat covers for different bucket seats. My front buckets are the wide low back ones with the steel back plates. The upgraded front buckets looks like they taper towards the top compared to mine that are more squared at the top. Are these seat covers the same? My next question is what did the basic K5’s have for side panels or where they just bare metal? The PO had particle board covered with carpet and fiberglass insulation behind them and it was wet and starting to rust the floor good thing I am doing this now.
__________________
1971 GMC K1500 SWB Fleetside, 4" skyjacker softride and, 14 Bolt FF, HD Dana 44 4.10's 1970 K5 TBI conversion lifted etc SOLD 1968 C20 camper truck SOLD “To ban guns because criminals use them is to tell the innocent and law-abiding that their rights and liberties depend not on their own conduct, but on the conduct of the guilty and the lawless.” Jeff Snyder |
|
|
| Bookmarks |
|
|
Threaded Mode