79 Chevy Pickup C-10 for parts

[dpmalibu]

Burgandy exterior/interior. Body has a newer paint job from a few years ago. Cab is almost rust free. Rust starting just a little in cab corners.There is a little rust on pass side inner rocker and floor support. Cab is 95% solid. I believe previous owner (owner before guy I bought it from) replaced everything (floors,Rockers, cab corners, doors and fenders. 3" Fibergalss cowl hood(bolt on w/ pins in front).Bed only has rust over the wheel wells on both 1/4's(Bubbling started .Pass side 1/4 has a little rot behind rear wheel.). Bed has bedliner with a huge bed toolbox(could fit a full size floor jack in it w/o handle) mounted at front of bed and diamond plate bed rail caps. All Cab and radiator support mounts were replaced with urethane mounts. Located in Trenton,NJ (609)481-8811



2) Custom rear bumper w/ drop hitch $75

3) (2) Doors (new) (manual windows) $125 ea. Comes with new mirrors

4) New fenders (2) $60 ea.

5) grill $40

5) headlight bezel trim (plastic) $20pr.

6) windshield $75

7) Rolling chassis w/ cab(with glass) and bed( no doors, seats, steering column,front clip, tailgate, rear bumper) $250 with title.Cab is 95% solid.

8) Alpine pull stereo $40

9) Big bedTool box $100 74"W x 28" deep x 18" high


11) 2 1/2" Dynomax w/ dumps $125

12) tailgate $60

13) rear slider glass $50

14) 12 bolt rear w/ 2.76 gears (open diff.)$100

15) Bucket seats (out of late 80's -early 90's Blazer/Suburban) $75

16) center console $ 30

17) overhead console $40

18) 305 motor out of an 87' Trans Am GTA runs good ( mileage somwhere b/t 65k-80k) needs valve seals. $100 for long block

19) factory gauge cluster w/ tach $50

20) Newer Holley 600 Vac. secondaries carb w/ electric choke $150(sale pending)

21) Edelbrock performer manifold center bolts holes were opened up to make it fit an 87-up SBC (Supposed to fit pre 87' SBC) Will still fit older SBC. $40 (sale pending)

Make offers on this stuff. Parts need to go.