|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
08-26-2006, 07:16 PM
|
#1 |
|
Registered User
 
Join Date: Jul 2006
Location: Pittsburgh, PA
Posts: 204
|
Best way to shrink metal when there is no acces to the rear of the panel?
I managed to use my new stud welder to pul some dents in the tailgate of my 71 but in one are in particular where the dent was BAD, the metal has streched a bit and is oil-canning in the lower left region of the tailgate. What is the best was to shrink this metal in order or prevent it fron oil canning?
Thanks
__________________
Project Family Values Build Thread Vehicles/Projects: -1971 C10 SWB Fleetside! Gathering parts now, will begin frame-off resto soon... Pleasure in the job puts perfection in the work. -Aristotle |
|
|
| Bookmarks |
|
|
Threaded Mode