|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-20-2006, 01:50 PM
|
#1 |
|
Registered User
Join Date: May 2005
Location: Beaverton, OR
Posts: 3,728
|
Where do I run the vacuum for my power booster?
I have an Edelbrock Performer manifold that has a few locations, but I wasn't sure if that was where I ran it to. Right now the only vacuum I have is running from the HEI to the carb. Do I just install a fitting on the back of the manifold and run it from there? I feel like a jackass because I didn't pay attention when I pulled it off the donor.
|
|
|
| Bookmarks |
|
|
Threaded Mode