Ladder bars on a "72"long bed - The 1947 - Present Chevrolet & GMC Truck Message Board Network

1972gasser · 10-20-2006, 11:26 AM

Hey man Is a wise decision to remove the stocky rear ladder bars and fabricate a hott pair of 66 inchers and weld up to the rear axle and install new brackets up front to mount the rod ends through on my "72"? Or just replace all the bushings with new urethane as well as all the old hardware clean up the stockys and re intall them. I'm going to run a set of 4:11's in my 12 bolt and would like to lock the rear axle in place in as best I can. Any sugestions or ideas?

10-20-2006, 11:26 AM	#1
1972gasser Registered User Join Date: Oct 2006 Location: Plano,Tx Posts: 13	Ladder bars on a "72"long bed Hey man Is a wise decision to remove the stocky rear ladder bars and fabricate a hott pair of 66 inchers and weld up to the rear axle and install new brackets up front to mount the rod ends through on my "72"? Or just replace all the bushings with new urethane as well as all the old hardware clean up the stockys and re intall them. I'm going to run a set of 4:11's in my 12 bolt and would like to lock the rear axle in place in as best I can. Any sugestions or ideas?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.