Pwr windows and locks

[gbkwork]

I recently purchased a 72 LWB in Nebraska, drove it back to CA and have been fixing it up since. This week, I am tackling PW and door locks from A1 Electric. After disassembling the doors and looking at the inside I have a question...where to attach the lock actuators? It looks like I can just drill a couple holes in the inside sheet metal (in an area that will be covered by the door panels). Has anyone else installed these? Also, how have you run the wires from door to jam? Help would be appreciated.

In the past couple weeks I've done the following:

17" Torq Thrusts w/ 255 & 275-50 Nittos
Dash pad
Heater controls
HEI disti
Hidden hitch from ECE
Chrome front & rear bumpers
Lighter assembly
New lock cores all around

After the windows & locks this long bed is going to get dropped...thinking 3.5" front & airbags back along with a front end rebuild and sway bar while I've got the thing apart.

It's a '72 Custom 350/350 4bbl and was bone stock when I bought it. This site has been a huge help so far.

Thanks,

gbkwork