What headers are you using for your BIG BLOCK?????

[novajess1972]

Sorry if this question has been run into the ground, but I am in the middle....correction....I am STUCK in the middle of replacing my 350 with a 468 big block. My motor mounts will not let the Hooker Headers nestle in place. On the pass side, I can get away with a little hammering/notching the header to fit in place. The driver side, however, is a different story. I need at least another 1 inch to 1 1/8 inch of clearance. Does anyone make less obtrusive motor mounts, or am I stuck paying out the ying yang for correct or custom headers? I saw a header thread for what seemd to be only small blocks. What headers can I use for my big block? And, yes, for a reasonable price. (read:cheap).

Any and all experiences and advice appreciated.

Jesse