One way to install universal windshield washer pump

[timcos]

This comes from some electrical help from Putter. Thanks Putter

This installation will allow the wiper switch (when depressed) to squirt the fluid.

1. New circuit for water flow

a. Install pump to fender ahead of the reservoir or your own chosen location.

b. Attach tubing from reservoir to suction on pump.

c. Cut old tubing at firewall.

d. Extend back the squirter tubing in your hand and cut to equal length (long enough to meet in the middle.) Be careful to not tug too hard and pull them off the squirters.

e. Attach squirter tubing to new T (comes with universal pump) and attached new hose (6 ft – 4.99 at checkers) to third leg of the new T.

f. Run new tubing down the guide to the side of the truck and forward. Attach it to the output of the pump

2. New electrical circuit so your pump will pump when you depress the stock switch.

a. Attach two wires to pump wire with approved electrical connection procedures.

i. I used 7 feet each of 18 gage yellow (power) and dark blue (ground)

b. Run them into the cab

c. Remove gage panel.

i. http://www.67-72chevytrucks.com/vboa...d.php?t=164357

d. Tap onto the YELLOW wire at the wiper motor. It is switched.

i. Use Yellow wire running to the cab from under the hood for connection.

e. Tap into the dark blue (ground) wire at the wiper switch.

i. Use Dark Blue wire running to the cab from under the hood for connection.

3. Test prior to reassembly.
4. Reassemble everything you disassembled.

The three pics below are

1. The tee under the hood near the cowl.
2. The pump motor location and routing of wires and hoses (5/32)
3. The electrical taps at the wiper motor and the switch.