|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-27-2006, 08:30 PM
|
#24 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,089
|
Re: What did you get done? Thanksgiving edition
We went across town to my GF's parents & watched the Cowboys win while chowing down. I ate well but didn't over do it.
Wed afternoon I got my notched crossmember + front frame section cleaned & rattle canned for the 68. After Thanksgiving, I started re-installing the c.member but ran into some alignment (or lack of) issues. I was on hold until Sat night when my buddy came by & verified my method of measurement was accurate (the front c.member is not 100% square w/the drag-link but measures square/diagonally on the frame  ).I still need to drill some new holes on the side of the frame since everything has been moved, but it's progress. Ken.... Get some fresh pics of the Camaro. I bet alot of people haven't seen just how nice of a car it is (or was  ).
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. Last edited by SCOTI; 11-27-2006 at 08:31 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode