68 Fender Emblem Question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

BigSky71 · 12-08-2006, 02:10 PM

I bought a 68 clip for my resto project that came off a 3/4 ton truck. I intend to place 1/2 emblems on the truck and need to know if the pin placement on the 1/2 emblems are the same as the 3/4 emblems. I have the fenders nearly ready for the first coat of primer but want to make sure my emblem holes are correct on the old fender and I need to drill them in the new fender, see picts. Obviously I haven't purchased the 1/2 emblems yet, that is about five phases away from the one I at currently

.

So can I just drill my new fender to match the old one?

12-08-2006, 02:10 PM	#1
BigSky71 LAIDOUT Join Date: Jan 2005 Location: NW Montana Posts: 928	68 Fender Emblem Question I bought a 68 clip for my resto project that came off a 3/4 ton truck. I intend to place 1/2 emblems on the truck and need to know if the pin placement on the 1/2 emblems are the same as the 3/4 emblems. I have the fenders nearly ready for the first coat of primer but want to make sure my emblem holes are correct on the old fender and I need to drill them in the new fender, see picts. Obviously I haven't purchased the 1/2 emblems yet, that is about five phases away from the one I at currently . So can I just drill my new fender to match the old one? Attached Images __________________ 67 2wd Shorty Build Pictures



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.