IFS Angles - The 1947 - Present Chevrolet & GMC Truck Message Board Network

54chevyls1 · 12-26-2006, 06:59 PM

I am putting an IFS from TCI in my 54 Chevy Truck. I finished welding in my boxing plates and got the cross member tacked in with it level from side to side and front to rear. I have the frame angled down from rear to front at 1.5 to 2 degrees. My issue is when I set the coil spring top hats on the frame they aren't even close to being level from side to side or front to rear. Are they supposed to be? This is my first IFS install so I am scared to grind away too much before I ask some questions. Any help would be appreciated. I did a quick search for this topic but didn't see anything related to this particular issue.

12-26-2006, 06:59 PM	#1
54chevyls1 Registered User Join Date: Dec 2006 Location: Tampa, FL Posts: 8	IFS Angles I am putting an IFS from TCI in my 54 Chevy Truck. I finished welding in my boxing plates and got the cross member tacked in with it level from side to side and front to rear. I have the frame angled down from rear to front at 1.5 to 2 degrees. My issue is when I set the coil spring top hats on the frame they aren't even close to being level from side to side or front to rear. Are they supposed to be? This is my first IFS install so I am scared to grind away too much before I ask some questions. Any help would be appreciated. I did a quick search for this topic but didn't see anything related to this particular issue. __________________



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.