Parts I need to finish my suspension

[IvelDesigns]

The following are parts i need to finish my suspension. I had planned to buy most of this stuff new, but figured i'd see if anyone needed to get rid of these items.

1.5" or 2" lowering blocks (coil rear end if that matters) - No Longer Need
Gas Tank - between the framerails, but not a blazer tank since they sit low
Rear shocks
Air gauges - 4 single needle or 2 double needle - No Longer Need
Rear wiring harness
Carrier Bearing - No Longer Need
Rear U-Joints for a split shaft - No Longer Need
2 Slam Speacialties Bags - RE7 (i have two i'm using for the rear already) - No Longer Need
2 Bag cups - cut down is ok since i plan to cut them down to 1" - No Longer Need
3" or 2.5" Drop spindles
Heater control for non-A/C - Silver face