350 pulleys question (was mis-posted in general section) - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**WorkinLonghorn** · 01-30-2007, 08:36 PM

Finally started my A.C. resto prjct,bought new hoses,clamps,figured out how the brackets go on this after-market set up.But with this "rebuilt" motor the AC belt hits the fan center portion.
>> If I get a smaller front pulley I think it will clear,like it did on the orig. eng.
>> The current pulley is about 6 1/2 inches. Were there other sizes available? Or is one available after-market like the one shown here only 5 inches or so?

01-30-2007, 08:36 PM	#1
WorkinLonghorn Senior Member Join Date: Dec 2006 Location: Studio City, Calif. Posts: 2,886	350 pulleys question (was mis-posted in general section) Finally started my A.C. resto prjct,bought new hoses,clamps,figured out how the brackets go on this after-market set up.But with this "rebuilt" motor the AC belt hits the fan center portion. >> If I get a smaller front pulley I think it will clear,like it did on the orig. eng. >> The current pulley is about 6 1/2 inches. Were there other sizes available? Or is one available after-market like the one shown here only 5 inches or so?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.