Sheetmetal for Gas Fill Neck Area Exist? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Ironhead · 02-15-2007, 04:36 PM

Did not see this topic listed anwhere... The sheet metal around the gas filler neck om my 68 panel has some rot around it. PO had spread some putty around the area - I would like to replace the area with new steel. It's surely an odd shape to reproduce. I previously purchased a entire suburban side to cut out just that area to replace it with but, just can't bring myself to cut up a nice side if one might be available. May post the side for sale at a later date. Any suggestions?

02-15-2007, 04:36 PM	#1
Ironhead Registered User Join Date: Feb 2007 Location: Westfield, Tioga County) Pennsylvania Posts: 113	Sheetmetal for Gas Fill Neck Area Exist? Did not see this topic listed anwhere... The sheet metal around the gas filler neck om my 68 panel has some rot around it. PO had spread some putty around the area - I would like to replace the area with new steel. It's surely an odd shape to reproduce. I previously purchased a entire suburban side to cut out just that area to replace it with but, just can't bring myself to cut up a nice side if one might be available. May post the side for sale at a later date. Any suggestions? __________________ Ironhead Mike '68 Panel 402BB '84 Shortbox 4X4 '85 Blazer '97 Silverado Ext. Cab



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.