Manual valves - The 1947 - Present Chevrolet & GMC Truck Message Board Network

CochinoFilipino · 03-06-2007, 02:57 PM

I'm going to put bags at all four corners. I want to keep it simple as possible. I might not even use a tank. But I still want to be able to control the rear from inside the cab.

The rear will be adjustable to handle loads. And also be independent side to side to counter roll. The front will be static.

I see two types of manual valves from MIC. One is a 2-port valve, that I'm guessing is either open or closed.

The other manual valve is a 3-port 2 position valve. But I don't know what the 2 positions are. Anyone know? I called and and got a busy signal. The picture shows the toggle in the middle, i wonder if it's actually a 3 postion valve.

03-06-2007, 02:57 PM	#1
CochinoFilipino Registered User Join Date: Feb 2006 Location: Republic of California Posts: 345	Manual valves I'm going to put bags at all four corners. I want to keep it simple as possible. I might not even use a tank. But I still want to be able to control the rear from inside the cab. The rear will be adjustable to handle loads. And also be independent side to side to counter roll. The front will be static. I see two types of manual valves from MIC. One is a 2-port valve, that I'm guessing is either open or closed. The other manual valve is a 3-port 2 position valve. But I don't know what the 2 positions are. Anyone know? I called and and got a busy signal. The picture shows the toggle in the middle, i wonder if it's actually a 3 postion valve. __________________ '67 C10 Short Stepside 5.0TPI/700R4 Last edited by CochinoFilipino; 03-06-2007 at 03:32 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.