last mile - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Srubydo1986 · 03-07-2007, 08:39 PM

ok on my project im at the very end. but im have a some troubles one in the transmission cooling lines what the best way to remove a fitting that wont come off. Its stuck and it slilly bent so the hose wont fit.

2nd problem is the rear of the drive shaft the u joint needs replacing but it appears to have something holding it in not the spring thing like normal it something else how do i remove it.

3rd is can i start an engine if the the transmission is connected but the torch convert is not leaving the flywheel to spin but not tranny. i turned the engine intell it almost started then stoped.

THINGS TO DO TO FINISH

tranny lines
drive shaft u joint and installation
torch convert bolts
install inspection cover
pure in fluids

after that im done

03-07-2007, 08:39 PM	#1
Srubydo1986 The Crazy Machanic Join Date: Jan 2007 Location: Nokesville Va Posts: 1,437	last mile ok on my project im at the very end. but im have a some troubles one in the transmission cooling lines what the best way to remove a fitting that wont come off. Its stuck and it slilly bent so the hose wont fit. 2nd problem is the rear of the drive shaft the u joint needs replacing but it appears to have something holding it in not the spring thing like normal it something else how do i remove it. 3rd is can i start an engine if the the transmission is connected but the torch convert is not leaving the flywheel to spin but not tranny. i turned the engine intell it almost started then stoped. THINGS TO DO TO FINISH tranny lines drive shaft u joint and installation torch convert bolts install inspection cover pure in fluids after that im done



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.