No Rear Brakes with lots of troubleshooting need help!! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

NPilot1975 · 03-18-2007, 09:27 PM

OK, I was driving my truck the last 2 weeks as my daily driver. I was suspect of my rear brakes and finally jacked it up this weekend to see if they were working and they weren't. First I tried the obvious and rebled all 4 brakes, with neg results. Then, I used CPP and some comments from the board and tried to reset the combination valve, still no rear brakes. At this point, I am not sure what else to try another than a new master cylinder. Attached below is a photo of my current setup. Is it the right one for disc front and drum rear? Thanx for any help.

03-18-2007, 09:27 PM	#1
NPilot1975 Senior Member Join Date: Aug 2002 Location: Plymouth, MA Posts: 891	No Rear Brakes with lots of troubleshooting need help!! OK, I was driving my truck the last 2 weeks as my daily driver. I was suspect of my rear brakes and finally jacked it up this weekend to see if they were working and they weren't. First I tried the obvious and rebled all 4 brakes, with neg results. Then, I used CPP and some comments from the board and tried to reset the combination valve, still no rear brakes. At this point, I am not sure what else to try another than a new master cylinder. Attached below is a photo of my current setup. Is it the right one for disc front and drum rear? Thanx for any help. Attached Images __________________ 1972 Blazer body...need to get a thread started for the rest of the story Last edited by NPilot1975; 03-18-2007 at 10:04 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.